Application

• Anchorage of bolts and fixings
• Permanent fixing of starter bars and fixings
• Installation of hand rails, safety fence, wall ties, railway tracks and ground anchors.
• Injection under base plates with minimum clearance

Advantages

• Exceptional bond to concrete and still surfaces
• Shrinkage-free hardening
• Rapid strength development
• Good chemical resistance

Instruction for Use

Surface Preparation

• Drill holes to proper diameter and length, Clean holes with a nylon brush.
• Blow concrete dust from hole with oil-free compressed air from back forward.

Mixing

Add component B to A and mix slowly until homogenous, and then pour PART C gradually while mixing until lump free mixture is achieved. The prepared grout has a pot life of about 30 min at 25˚c.

Placing and Finishing

• Fill holes 1/2 to 3/4 full beginning at the bottom of hole.
• Insert the anchor bolt, threaded rod or rebar to the bottom of the hole while turning clockwise.
• The bolt or fixing must be left undisturbed until the resin has set.
• GF1 has flowable consistency so can be poured easily into the holes in floors or slope sleeves.
• GF2 has thixotropic consistency and non slump properties, but in case of high temperatures use capping to avoid outflow of the grout from the sleeve prior to setting.
• The suitable ambient, mixture and component temperatures are between 18 to 28˚c, it is recommended to keep the components at the desired temperatures long enough prior to grouting.

Packaging

GF1 and GF2 are supplied as follow:

GF1:           A=1 kg           B=500 g          C=2.1 kg

GF2:           A=1 kg           B=500 g          C=4.2 kg

Shelf life and Storage

1 year when stored in the unopened container in a dry location.

Technical Service

The SHIMISAKHTEMAN Technical Service Department is available to assist you in the correct use of our products in the field.