FARTEX 2000 is a one component; crystalline capillary water proofing system based on specially selected hydraulic cements, Mineral Powders, Quartz sands and many effective active chemicals.
2000 penetrate into the pores and react chemically with free lime in the presence of water to produce insoluble crystals.
Sewage treatment plants
Basements, Tunnels, elevator pits reservoirs, foundations and pipes
Manholes, subway stations and mines
Repairing the hair crack on the surface of concrete
Recommended for use with potable water
Concrete surface can breathe after application a treated concrete resists de-icing salt and chemical attack of sewage and industrial wastes and carbonation.
Permanent waterproofing and active to react all the time
No need for primer and surface leveling
Effective water proofing treatment against hydrostatic pressure-both positive and negative.
Method of use
Surfaces must be clean and sound. Remove all oil, dirt, laitance and coatings and any product which resist penetration of FARTEX 2000 by water blasting.
For optimum crystallization the surface must have an open capillary system and well absorptive, it is recommended to remove the surface layer with sandblasting.
Concrete defects, cracks, honeycombs must be opened removed and routed to sound material
Surface must be saturated for application of FARTEX 2000
Repair the prepared area with pasty FARTEX 2000
Mix 1 part clean potable water to 2 parts powder by volume for brush and spray application
Mix 1 part clean potable water to 3 parts powder by volume for repair
Mix thourouly with slow speed drill to homogenous and lump free slurry, if mixture thickens, re-stir to reduce consistency.
The surface must be pre dampened
Can be applied with a brush, broom or spray
Fill the cracks and defects with part form of FARTEX 2000
Mix enough slurry to be applied in less than 20 minuets
Apply the second layer after first coat has taken an initial set. If the first coat has dried out, moisten surfaces before applying second coat. The previous coat must not be damaged during application of the following coat.
The treated surfaces which are to be coated or painted must be cleaned and the cured product removed by acid etching or water or sand basting at least 28 days after application.
The treated surfaces must be dampened for at least 5 days, every 8 hours
For concrete with high porosity, curing should be extended
700 g to 1200 g for each coat depending on the substrate porosity and condition.
Other product info
FARTEX 2000 is supplied in 20 kg plastic bags.
12 month from date of manufacture if stored in unopened original packing in day, frost-free condition.
Office Address: No. 242, First floor, Mirdamad Blvd, Tehran, Iran
Contact Number: +98-21-27427
Factory address: East third and second, Simin Dasht Industrial Town, Shahriar Road, Karaj, Iran.
Contact number: +98-26-36670012-3-4
The company has been operating since 1972 under the management of Massoud Honarmand. Shimisakhteman holds a production license from the Ministry of Industry, Mining and Trade and has a mandatory standard certification of 2930. We have been selected as a standard sample unit every year since the 90’s.